Win 10 found the driver (somewhere), installed it and, sure enough, the Arduino IDE can find the port. I bought a few clones and just plugged one in. I had heard nothing but badness about getting them to work. Think about the dreaded CH340 USB->Serial device on clone Arduinos. Drivers are found automatically, I don't need to go wandering all over the Internet looking for them. Being run in this bizarre way, it runs quicker on the new laptop than on the old one (but then again the new one is 2.4GHz processor speed vs 1.9GHz processor speed for the old laptop)Įverything I plug in just works. Are there any disadvantages of this? One slight disadvantage is that you have to open simulations from the LTspice window instead of just clicking them and having them automatically open up LTspice for us. This is weird, howcome LTspice is running on the new laptop even though its not installed on the new laptop? At least its not crashing now. Does anyone know what's going on here? If i go into the Programs folder on the new laptop, which lists all the programs that are installed on the new laptop, then LTspice doesnt show up here. However, if i click the file called "SCAD3" in the LTspice folder than it opens up the LTspice window and this lets me open simulations (.asc files) and runs them. So LTspice is now obviously not actually installed on the new laptop. Therefore, i have copied the whole LTspice folder (called "LTC") and just dumped it into a file on the desktop of the new laptop. OK, i went into the "Program Files (x86)" folder of our old laptop, and tried to find the LTspice IV install file, so i could install it onto our new laptop. Being run in this bizarre way, it runs quicker on the new laptop than on the old one (but then again the new one is 2.4GHz processor speed vs 1.9GHz processor speed for the old laptop)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |